USB2.0 (ULPI/OTG) Snap On Board

INTRODUCTION |

FEATURES |

BLOCK DIAGRAM

The USB 2.0 (ULPI/OTG) Snap On Board is designed to provide connectivity between USB 2.0 Host / OTG controller and USB 2.0 Device IP core. The Snap On board provides a fast, versatile, and easy-to-use communication path for data exchange between the device and host. The board provides complete Hi-Speed USB 2.0 physical front-end solution that supports high-speed (480 Mbit/s), full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s).

Features

Operates in Low Speed (1.5 Mbps), Full Speed (12Mbps) and High Speed (480Mbps).
ULPI PHY Chip - NXP ISP1504
Serial to Parallel and Parallel to Serial conversion
Provides 8-bit bidirectional data interface
A current limited External V_BUS Power Switch with thermal shutdown
USB Mini AB-type connector
One Power LED and one User LED
Standard SantaCruz interface and GPIO interface support
Fully complies with:

Universal Serial Bus Specification Rev. 2.0
On-The-Go Supplement to the USB 2.0 Specification Rev. 1.2
UTMI+ Low Pin Interface (ULPI) Specification Rev. 1.1

Block Diagram

View Full size

Deliverables

USB 2.0 ULPI Snap On Board
USB 2.0 ULPI CABLE
CD ROM

USB20HR IP Core (USB 2.0 Device Controller - Avalon interface) evaluation version
USB20HF IP Core (USB 2.0 Device Controller - FIFO interface) evaluation version
USB20HC IP Core (USB 2.0 Host Controller) evaluation version
Board Reference Manual

Related Products

CoreCommander board (Cyclone III FPGA)

USB 2.0 (UTMI) Snap On Board

USB 2.0 IP Core

Logic Analyzers and Pattern Generators

Downloads