The USB BitJetLite interfaces a USB port on a host computer to an Altera^® FPGA mounted on a printed circuit board. The cable sends configuration data from the PC to a standard 10-pin header connected to the FPGA. You can use the USB BitJetLite to iteratively download configuration data to a system during prototyping or to program data into the system during production.

• Download configuration data to FPGA devices
  • Stratix^® series FPGAs
  • Cyclone^® series FPGAs
  • Max^® series CPLDs
  • Arria^® series FPGAs
• In-system programming of the following devices :
  • Serial configuration devices including EPCS1, EPCS4, EPCS16, EPCS64 and EPCS128 devices
• Perform Signal Tap^® II logic analysis
• Supports target systems using 3.3 V LVTTL/LVCMOS and single-ended I/O standards from 1.5 V to 3.3 V

Power Requirements

• 5.0 V from the USB cable
• Between 1.5 V and 3.3 V from the target circuit board

Software Requirements

• Windows XP (32-bit and 64-bit) with service pack 2, Windows Vista (32-bit and 64-bit) and Windows 7 (32-bit and 64-bit) systems
• Quartus II Programmer (for programming and configuration)
• Quartus II SignalTap^® II Logic Analyzer (for logic analysis)
• Quartus II Programmer (standalone version)
• Quartus II SignalTap II logic analyzer (standalone version)

• Installation CD
  • Drivers for Windows XP with SP2, Windows Vista, Windows 7 32/64 bit
• USB Cable

Actual Performance Data

For more information, contact This e-mail address is being protected from spambots. You need JavaScript enabled to view it .

• USB BitJetLite (Full Speed) Brochure
• USB BitJetLite (Full Speed) User Guide